Automotive Scan Tools, Diagnostic Equipment and Torque Calibration Specialists
How To Guide:
Source: LAUNCH TECH CO LTD
LAUNCH DFM JoyearX 2017 Tire Pressure Sensor Learning Guide
Just a Heads-Up: This guide is here to help you out, but it’s for general info only. We try to keep everything accurate and reliable, but we can’t promise it’s perfect. So, if you decide to follow this guide, you’re doing it at your own risk. We’re not responsible for any loss or damage that might happen, including indirect or consequential loss, or any loss of data or profits from using this guide. Sometimes, we might link to other websites. We don’t control those sites, so we can’t vouch for their content. Just because we link to them doesn’t mean we endorse them. We do our best to keep this guide running smoothly, but we can’t be held responsible if it’s temporarily unavailable due to technical issues beyond our control.
Model information:
2017 DFM Joyear X6
Function description:
Replace the tire pressure sensor to learn the operation guide
Used tools:
CRT511S (This operation takes CRT511S as an example, the specific operation of other tire pressure equipment can refer to this method)
Device version information:
V1.23 or later
Sensor OE number:
(BAOLONG) BS33685020
Fault description:
Abnormal tire pressure is reported, the left rear wheel pressure display is not consistent with the actual tire pressure, and the tire pressure lamp is lit, as shown in the figure below;
Procedure:
1. Select the Launch [CRT511S], select the function of [Tire Pressure System], and select the corresponding menu according to the information on
the vehicle nameplate:
DFM →X6→[2017/01-2018/06 (433MHZ) ] Enter the function list
Select the [Check Sensor] function to activate the tire pressure sensor inside the tire. It is found that the activated air pressure of the left rear sensor is
2KPa and the actual air pressure is 220KPa, which is judged to be inaccurate sensor damage data (activation failure indicates that the sensor is damaged and needs to be replaced).
2. Go back to the previous level and select the [Program Sensor] function, then select [ Automatic Creation] to program a Launch tire pressure sensor.
3. Load the programmed sensor into the car to replace the bad tire pressure sensor, as shown in the following figure
4. Go back to the previous level and click the [Check Sensor] function again to activate the replaced left rear tire pressure sensor (save it when the device
prompts whether to save the activated data, otherwise all sensors need to be activated again) as shown in the following figure.
5. Go back to the upper level to select the [Relearn] function, and operate according to the operation prompts. The learning is successful, as shown in
the following figure (Note: OBD learning is to write the sensor ID and position of the activation interface into the tire pressure computer of the vehicle)
6. After the sensor is successfully learned, click the "Enter" button to read the ECU ID to determine whether the learning is successful (Note: If the ID
is correctly displayed, the font color is black; if the ID is incorrectly displayed, the font is red)
7. Select the [TPMS OBDII] function on the function selection page, and then select the [Read DTCs] function, as shown in the figure (if there is a fault
code, you need to perform the [Clear DTCs] function).
8. The tire pressure sensor was successfully replaced, the indicator tire pressure indicator was turned off, the pressure of all four tires was increased
to 220kpa, and the tire pressure was tested at 30km/h or above for 15min.
No abnormal alarm occurred again, and the problem was solved.
