Automotive Scan Tools, Diagnostic Equipment and Torque Calibration Specialists
How To Guide:
Source: LAUNCH TECH CO LTD
LAUNCH Ford Steering System Steering Angle Sensor Calibration Instructions Mondeo 2012
Just a Heads-Up: This guide is here to help you out, but it’s for general info only. We try to keep everything accurate and reliable, but we can’t promise it’s perfect. So, if you decide to follow this guide, you’re doing it at your own risk. We’re not responsible for any loss or damage that might happen, including indirect or consequential loss, or any loss of data or profits from using this guide. Sometimes, we might link to other websites. We don’t control those sites, so we can’t vouch for their content. Just because we link to them doesn’t mean we endorse them. We do our best to keep this guide running smoothly, but we can’t be held responsible if it’s temporarily unavailable due to technical issues beyond our control.
2012 Ford Mondeo Steering Angle Sensor Calibration Instructions
Product Model
X-431 Pro series
Tested Model:
Ford Mondeo, 2012, VIN=WFOGXXGBBGCB*****
NOTES:
This function is used to configure the steering angle sensor and calibrate the steering wheel position. Perform this function when corresponding sensors are
replaced or the steering wheel position is not accurate.
Keep the vehicle on a flat surface, and the steering wheel is set at straight ahead position.
Operation Procedure:
1).Select Ford version above V45.20.
2).Select automatic search.
3).Select Fuel Type=Gasoline.
4).Select “System Selection”
5).Select ABS(Anti-lock Brake System)/ESP(Electronic Stability Program) exhaust.
6).Check vehicle status and ensure that the vehicle is in required status: Vehicle on a flat surface, and the steering wheel is set at straight ahead position.
7).Select Special Function
8).Place the key to ON position in order to turn the steering wheel. Because of the great force of friction between tires and the ground, in order to turn the steering wheel more easily, it is advised to start the engine at this moment.
9).Turn the steering wheel to the left and right respectively about 10 degree, then back to the straight ahead position.
10).After clicking OK, it counts down from 4 seconds configuring the module.
11).It prompts the procedure succeeded once the ECU configuration completed.
12).After this procedure succeeded, some vehicles may produce fault code due to this function execution, thus it is required to do self-test and clear the DTC, but
most of the vehicles will not set fault codes.
13).After confirmation, it prompts to turn the ignition key to OFF to end the test.
