LAUNCH Operating Instructions for BMW E Chassis 8HP EGS Erasure Function

Just a Heads-Up: This guide is here to help you out, but it’s for general info only. We try to keep everything accurate and reliable, but we can’t promise it’s perfect. So, if you decide to follow this guide, you’re doing it at your own risk. We’re not responsible for any loss or damage that might happen, including indirect or consequential loss, or any loss of data or profits from using this guide. Sometimes, we might link to other websites. We don’t control those sites, so we can’t vouch for their content. Just because we link to them doesn’t mean we endorse them. We do our best to keep this guide running smoothly, but we can’t be held responsible if it’s temporarily unavailable due to technical issues beyond our control.

Operating Instructions for BMW E Chassis 8HP EGS Erasure

Function introduction

Erase BMW E Chassis 8HP transmission ECU. To replace the disassembled transmission ECU, it cannot be programmed directly. It needs to be erased before programming and

using.

Support second-hand 8HP transmission erasure for BMW E70/E71/E72/E81/E82/E84/E87/E89/E90/E91/E92/E93.

Device requirements

PRO and other Android devices of 431 products, X 431-G/X431-G3 Immobilizer with key adapter;

Software requirements

IMMO matching V10.90 and above

Steps

1. The following is a detailed introduction to the E Chassis 8HP transmission ECU Erasure function.

1.1 Enter the software, and select [IMMO]

1.2 Enter the software, and select [OK]

1.3 Select [BMW]

1.4 Switch On ignition and click [OK]

1.5 Click [Yes] to enter the related function menu

1.6 Select [Anti-Theft Function]

1.7 Connect with X431-G/X431-G3, and click [OK]

1.8 Select [EGS System]

1.9 Select [E chassis 8HP]

1.10 The transmission ECU can be installed on vehicle through OBD to erase, or it can be erased by directly connecting to the ECU. For the pins of direct connection

1.11 Select [EGS Erasure]

1.12 Erasure of EGS requires upgrading the Flash. Please connect to the network and ensure the supply voltage is not below 13V and is stable, and click [Yes]

1.13 Erasure of EGS requires downloading the programming file, upgrading and restoring it. This process is continuous and takes 10 to 20 minutes, please wait for it