Automotive Scan Tools, Diagnostic Equipment and Torque Calibration Specialists
How To Guide:
Source: LAUNCH TECH CO LTD
LAUNCH TPMS Land Rover Range Rover 2021 Tire Pressure Sensor Learning Operation Guide
Just a Heads-Up: This guide is here to help you out, but it’s for general info only. We try to keep everything accurate and reliable, but we can’t promise it’s perfect. So, if you decide to follow this guide, you’re doing it at your own risk. We’re not responsible for any loss or damage that might happen, including indirect or consequential loss, or any loss of data or profits from using this guide. Sometimes, we might link to other websites. We don’t control those sites, so we can’t vouch for their content. Just because we link to them doesn’t mean we endorse them. We do our best to keep this guide running smoothly, but we can’t be held responsible if it’s temporarily unavailable due to technical issues beyond our control.
Function description:
Tire pressure sensor learning guide after tire pressure sensor replacement.
Using tools：
CRT 511S (This operation takes CRT 511S as an example, and specific operation methods for other tire pressure equipment of LAUNCH can refer to this method.)
Model information:
2021 Land Rover Range Rover
Sensor OE number：
(Continental) M8E21A159AA
Fault description：
The tire pressure light on the instrument panel is on, indicating that the left rear wheel pressure has been monitored, and the pressure value is not displayed on all four wheels, as shown in the following figure.
Procedure:
1. Activate the four sensors on the vehicle in sequence according to the corresponding positions, and it is found that the left rear wheel cannot be activated, as shown in the figure below.
2. Return to the main page for sensor programming, the device automatically creates a new ID and installs the programmed elemental tire pressure sensor into the tire, as shown in the figure below.
3. Check that the learning type of the car is automatic learning, as shown in the figure below.
4. The vehicle is locked and dormant for 20 minutes, with a speed of no less than 30km/h for at least 10 minutes until the learning is completed. After the learning is completed, the tire pressure light goes out and the tire pressure value is displayed normally, as shown in the figure below.
