top of page

How To Guide:

Source: LAUNCH TECH CO LTD

LAUNCH TPMS Nissan Patrol Tire Pressure Sensor Learning Operation Guide

Just a Heads-Up: This guide is here to help you out, but it’s for general info only. We try to keep everything accurate and reliable, but we can’t promise it’s perfect. So, if you decide to follow this guide, you’re doing it at your own risk.  We’re not responsible for any loss or damage that might happen, including indirect or consequential loss, or any loss of data or profits from using this guide.  Sometimes, we might link to other websites. We don’t control those sites, so we can’t vouch for their content. Just because we link to them doesn’t mean we endorse them.  We do our best to keep this guide running smoothly, but we can’t be held responsible if it’s temporarily unavailable due to technical issues beyond our control.

Function description：

Tire Pressure Sensor Learning Operation Guide.


Using tools：

CRT 511 (This operation takes CRT 511 as an example, and

specific operation methods for other tire pressure equipment of LAUNCH

can refer to this method.)


Model information:

2018 Nissan Patrol


Sensor OE number：

(Pacific) 407003HN0B/407005ZH0A


Fault description：

The instrument tire pressure light is on (as shown in the

following figure);


Procedure:

1. Activate the four sensors on the vehicle in sequence according to the corresponding positions, and it is found that the right rear wheel cannot be activated, indicating a fault with the right rear tire pressure sensor, as shown in the figure below.

2. Return to the main page and click on Sensor Programming. The device will automatically create a new ID and install the programmed LTR-Sensor into the right rear wheel, as shown in the figure below.

3. Return to the home screen to select [Relearn], as shown in the figure below.

4. Prompt to save activated data? Click OK to save, as shown in the following figure.

5. This page can activate the sensor. If you need to modify it, you can reactivate it. After confirming that there are no errors, click the confirm button, as shown in the figure below.

6. The activation information cannot be modified on this page. Once confirmed, click the confirm button, as shown in the figure below.

7. The device prompts that the sensor has learned successfully, as shown in the figure below.

8. After successful learning, the tire pressure light turns off, as shown in the figure below.


bottom of page