Automotive Scan Tools, Diagnostic Equipment and Torque Calibration Specialists
How To Guide:
Source: LAUNCH TECH CO LTD
LAUNCH VW Crash Shut Off Activation Reset Tayron 2019
Just a Heads-Up: This guide is here to help you out, but it’s for general info only. We try to keep everything accurate and reliable, but we can’t promise it’s perfect. So, if you decide to follow this guide, you’re doing it at your own risk. We’re not responsible for any loss or damage that might happen, including indirect or consequential loss, or any loss of data or profits from using this guide. Sometimes, we might link to other websites. We don’t control those sites, so we can’t vouch for their content. Just because we link to them doesn’t mean we endorse them. We do our best to keep this guide running smoothly, but we can’t be held responsible if it’s temporarily unavailable due to technical issues beyond our control.
VW Crash Shut-Off Activation Reset Steps Volkswagen TAYRON 2019
Model:
Volkswagen TAYRON 2019
Vehicle VIN：
LFV3B25N1K702****
Symptom:
Engine cannot start after the accident; the engine light is on, the data bus diagnostic interface system reports B189CF0 collision switch activation fault code
Solution:
Collision switch reset
Starting conditions:
The ignition switch is turned on, do not the start the engine, and the battery voltage is above 12V.
Steps:
1.“19 Gateway” system reports B189CF0 crash shut-off activation fault code.
2. Enter “19 Gateway” system, select the option “Basic Settings”.
3. Select the option ‘Reset Of Reversible Crash Shut-Off’ checkbox and click OK to enter.
4. Click the lower left corner to adjust to reset.
5.Until the basic setting status is displayed ‘Finished correctly’, just need clearing the fault code and start vehicle to check whether fixed.
