top of page

How To Guide:

Source: LAUNCH TECH CO LTD

LAUNCH VW Steering Angle Learning Steps Golf 2013

Just a Heads-Up: This guide is here to help you out, but it’s for general info only. We try to keep everything accurate and reliable, but we can’t promise it’s perfect. So, if you decide to follow this guide, you’re doing it at your own risk.  We’re not responsible for any loss or damage that might happen, including indirect or consequential loss, or any loss of data or profits from using this guide.  Sometimes, we might link to other websites. We don’t control those sites, so we can’t vouch for their content. Just because we link to them doesn’t mean we endorse them.  We do our best to keep this guide running smoothly, but we can’t be held responsible if it’s temporarily unavailable due to technical issues beyond our control.

VW 6 Steering Angle Learning Steps Golf 2013


Models:

Golf 2013


Symptom:

The four-wheel alignment the back direction lights, ABS lights, and side-slip lights are on, and the power steering system reports 03803 steering angle without basic setting fault code.


Solution:

Steering angle reset


Used equipment:

X431-PRO3 V3.0


Software Version:

V28.66


Steps:

1. Select the car system software to enter, select’ 44 Steering Assistance’, select ’16 Access Permission’:

2. Click OK to enter the secure login.

3. Input’ 40168 ‘and click ‘OK’ to log in.

4. Click OK after successful login.

5. Select ‘Basic Settings’ option to enter.

6. Select ‘Read By List’ option.

7. Select the ‘060, Adjustment Of Steering Angle Sensor’ option, then click the lower right corner ‘OK’.

8. After entering, compare the positive and negative angles of the steering angle. The difference between the positive and negative angles is preferably within value 10 degrees. Turn the left steering wheel to the end. The current positive angle is 494.10 degrees.

9. The negative angle is 492.00, and the angle difference is within 10 degrees, which can be reset.

10. When the steering wheel is back to the original direction, the steering angle sensor (G85) must be displayed the value ‘Possible’, then leave the steering wheel with both hands and click the ‘ADJUST’ option in the lower left corner.

11. The’ Adjustment-Status ’ option shows that it has been calibrated.

Exit and clear ssthe fault code then do a road test. The fault light sometimes goes out after the road test. If the road test light still does not go off, repeat the reset procedure.


bottom of page