How To Guide:

Source: SmartSafe

SmartSafe ADAS Honda 2016 ELYSION ADAS Calibration Operation Instructions

Just a Heads-Up: This guide is here to help you out, but it’s for general info only. We try to keep everything accurate and reliable, but we can’t promise it’s perfect. So, if you decide to follow this guide, you’re doing it at your own risk. We’re not responsible for any loss or damage that might happen, including indirect or consequential loss, or any loss of data or profits from using this guide. Sometimes, we might link to other websites. We don’t control those sites, so we can’t vouch for their content. Just because we link to them doesn’t mean we endorse them. We do our best to keep this guide running smoothly, but we can’t be held responsible if it’s temporarily unavailable due to technical issues beyond our control.

Measured models:

Honda ELYSION, 2016 model, VIN: LHGR83839E********

Execution premise:

(1) The vehicle has the following failure records (no or wrong basic settings/adaptation)

① B2A60-54 — Static camera alignment not done.

② B2A60-52 — Dynamic camera alignment not done.

(2) Vehicle parts are overhauled and replaced as follows:

① Removed or replaced the camera or replaced the windshield.

② Updated wheel damping electronics or one of the vehicle height sensors of the height control system.

Precautions

① All fault memory entries not related to calibration must have been processed.

② The camera is clean, the field of view is unobstructed, and there is no direct light source on the opposite side.

③ During dynamic alignment, it is necessary to keep driving at a speed of 72-110Km/h (45-70mph) and keep driving in the middle of the lane.

Operation guide:

1. Scan the VIN, automatically match and select the model.

2. Enter the HONDA software, select the region "USA".

3. Get vehicle information.

4. Click "OK" to enter the ADAS Calibration module.

5. Select the "ADAS Calibration Function'' sub-module to display the function interface.

6. Select the "Front Camera Calibration" function, and display the sub-functions: Static Camera Aiming and Dynamic Camera Aiming.

7. Select "Static Camera Aiming", and display different ADAS calibration devices. Select according to the purchased ADAS calibration device, and now select "ADAS Mobile".

8. Please check the pre-calibration preparation information in detail: fault information, site information, and remove obstacles in front of the vehicle.

9. Click "Next Step" to enter the prompt interface of ADAS target device placement. Click "Set Up" to viewthe placement steps of the target device, and click "Calibration" to execute the calibration function.

10. Click "Set Up" to view the placement steps of the target device: determine point A and point B, and determine the centerline of the vehicle.

11. Determine the distance of target placement, L = 6000mm.

12. Fixed ADAS Mobile position.

13. Adjust ADAS Mobile so that it is parallel to the vehicle.

14. Adjust the height of ADAS Mobile, H = 1150mm.

15. Click "OK" to check whether the target device meets the conditions. Display the standard value of the front hub height of the vehicle, measure the height of the left and right front hubs of the vehicle, and calculate the error range from the standard value.

16. According to the error range, select the following menu, such as: -15mm to -5mm.

17. Click "Next Step" to start calibrating the intermediate target.

18. The intermediate target is calibrated. Install LAM01-20 to the left side, W=800mm.

19. Click "Next Step" to start calibrating the left target.

20. The target on the left is calibrated. Install LAM01-20 to the right side, W=800mm.

21. Click "Next Step" to start calibrating the right target.

22. The right target is calibrated. Static Camera Aiming has been completed, turn off the ignition switch, then turn on the ignition switch, and check the ADAS report.