SmartSafe ADAS LANDROVER Range Rover Velar 2018 Forward Radar Calibration

Just a Heads-Up: This guide is here to help you out, but it’s for general info only. We try to keep everything accurate and reliable, but we can’t promise it’s perfect. So, if you decide to follow this guide, you’re doing it at your own risk. We’re not responsible for any loss or damage that might happen, including indirect or consequential loss, or any loss of data or profits from using this guide. Sometimes, we might link to other websites. We don’t control those sites, so we can’t vouch for their content. Just because we link to them doesn’t mean we endorse them. We do our best to keep this guide running smoothly, but we can’t be held responsible if it’s temporarily unavailable due to technical issues beyond our control.

Function Description:

The camera needs to be calibrated in the following cases：

1) There is a fault code C1A67-54 Forward Looking Sensor - Missing Calibration in the CCM system.

2) There is a fault code C1A67-78 Forward Looking Sensor – Alignment or Adjustment Incorrect in the CCM system.

Operation guide:

1. Automatically identify the model Range Rover Velar (2018) through ADAS calibration entrance VIN.

2. After selecting "ADAS Calibration Function", click "ACC Radar Calibration".

3. Select "Activate Forward Radar Service Alignment".

4. Follow the prompts to operate, please ensure that all vehicle-related faults are corrected, click "OK".

5. According to the prompts, the battery voltage of the vehicle is required to be 12V. After confirming that it is correct, click "YES".

6. Follow the prompts, turn on the ignition switch, and click "OK".

7. Read the suggestions in the prompt carefully while the software is running, and click "OK" after confirming that it is correct.

8. Read the prompt carefully, make sure the "Follow Icon" indicator light is flashing, and click "OK" after confirming that it is correct.

9. When the software is running, when the blinking "Follow Icon" light goes out. That is, when "Service Align Completion Percentage" reaches 100%, it means that the system has been calibrated correctly, and it will automatically jump to the next interface.