SmartSafe ADAS Mercedes-Benz ML300 Night Vision Assist System Calibration

Just a Heads-Up: This guide is here to help you out, but it’s for general info only. We try to keep everything accurate and reliable, but we can’t promise it’s perfect. So, if you decide to follow this guide, you’re doing it at your own risk. We’re not responsible for any loss or damage that might happen, including indirect or consequential loss, or any loss of data or profits from using this guide. Sometimes, we might link to other websites. We don’t control those sites, so we can’t vouch for their content. Just because we link to them doesn’t mean we endorse them. We do our best to keep this guide running smoothly, but we can’t be held responsible if it’s temporarily unavailable due to technical issues beyond our control.

Functional description

When calibration is required:

① Replace the front windshield.

② Lost calibrated or uncalibrated DTC appears.

③ Structural Changes/Chassis Adjustments

④ Replace the night vision camera.

Precautions

① Put the vehicle stationary on level ground, the tire pressure is normal, and the wheel alignment is normal.

② The steering angle of the steering wheel is 0.

③ Please place the target correctly according to the steps prompted by the device.

④ The front of the vehicle is well-lit.

Operation steps

1. Turn on the ignition switch of the car, connect the diagnostic equipment, select the Mercedes-Benz model software, and enter the following menu interface.