Automotive Scan Tools, Diagnostic Equipment and Torque Calibration Specialists
How To Guide:
Source: SmartSafe
SmartSafe ADAS Porsche Cayenne 92A 2015 Adaptive Cruise Control System Calibration
Just a Heads-Up: This guide is here to help you out, but it’s for general info only. We try to keep everything accurate and reliable, but we can’t promise it’s perfect. So, if you decide to follow this guide, you’re doing it at your own risk. We’re not responsible for any loss or damage that might happen, including indirect or consequential loss, or any loss of data or profits from using this guide. Sometimes, we might link to other websites. We don’t control those sites, so we can’t vouch for their content. Just because we link to them doesn’t mean we endorse them. We do our best to keep this guide running smoothly, but we can’t be held responsible if it’s temporarily unavailable due to technical issues beyond our control.
Background
The vehicle has the following failure records (no or wrong basic settings/adaptation)
(1) D00008 – Calibration
Vehicle parts are overhauled and replaced as follows:
(1) Radar sensor is loose or replaced.
(2) Loose bumper bracket or replace.
(3) Sensor locking bracket is loose or removed.
(4) Wheel suspension geometry changes.
(5) The rear end inside the front of the vehicle is impacted by an external force.
Precautions
Preparations before calibration:
(1) Turn on the car ignition switch.
(2) Radar sensor is loose or replaced.
(3) Loose bumper bracket or replace.
(4) Sensor locking bracket is loose or removed.
(5) Wheel suspension geometry changes.
(6) The rear end inside the front of the vehicle is impacted by an external force.
Applicable models:
Porsche Cayenne 92A 2015
Instructions
Set up calibration aids:
(1) Place the ADAS calibration device in the center of the front of the vehicle.
(2) Install the radar reflector (LAC05-02) on the beam of the ADAS calibration equipment and place it in position 2.
(3) The distance between the radar reflector (LAC05-02) and the radar sensor is L=1200±25mm.
(4) Adjust the ADAS calibration equipment to align horizontally with the vehicle.
(5) Attach the magnetic laser mount (LAC05-01) to the center of the radar reflector (LAC05-02), adjust the height of the beam or move the position of the radar reflector (LAC05-02), so that the laser point is located at the center of the radar sensor; If the radar sensor is equipped with a reflector, the laser light hits the center of the reflector, and the radar positioning bolt is adjusted so that the reflection point is located in the center of the scale plate of the magnetic laser seat (LAC05-01).
(6) After the position is aligned, remove the magnetic laser mount (LAC05-01).
Operation steps
1. The diagnostic tool starts communicating with the VCI and reads the VIN.
2. After the VIN is resolved successfully, the system will automatically enter the ADAS function selection interface. Here we select the “Adjusting Adaptive Cruise Control System” function.
3. Click "Adjusting Adaptive Cruise Control System" to enter the Adjusting Adaptive Cruise Control System function.
4. Follow the instructions and click "OK" to continue.
5. Carefully read the calibration operation requirements, and confirm that all calibration conditions are met. If satisfied, click "OK".
6. Referring to the target setting, adjust the LAC position. When done, click OK.
7. Next, please operate according to the Status value of "Adjustment Instructions".
8. Set the adjustment screws 1 and 2, then click "OK".
9. After the adjustment is completed, the following prompt will appear, click "NEXT".
10. It will display that the calibration has been performed successfully, click "OK" to end the function.
