Automotive Scan Tools, Diagnostic Equipment and Torque Calibration Specialists
How To Guide:
Source: SmartSafe
SmartSafe ADAS SUBARU North America Impreza 2016 ADAS Radar Calibration
Just a Heads-Up: This guide is here to help you out, but it’s for general info only. We try to keep everything accurate and reliable, but we can’t promise it’s perfect. So, if you decide to follow this guide, you’re doing it at your own risk. We’re not responsible for any loss or damage that might happen, including indirect or consequential loss, or any loss of data or profits from using this guide. Sometimes, we might link to other websites. We don’t control those sites, so we can’t vouch for their content. Just because we link to them doesn’t mean we endorse them. We do our best to keep this guide running smoothly, but we can’t be held responsible if it’s temporarily unavailable due to technical issues beyond our control.
Functional description:
The following situations need to be calibrated
1) Radar sensor is loose or replaced.
2) Loose bumper bracket or replace.
3) Sensor locking bracket is loose or removed.
4) Wheel suspension geometry changes.
5) The rear end inside the front of the vehicle is impacted by an external force.
Precautions
All fault memory entries not related to calibration must have been processed.
Measured model
SUBARU North America Impreza 2016
Operation steps：
1. Select [ADAS] to enter the following interface.
2. Enter the system scanning interface after reading the VIN code.
3. Scan for systems with ADAS function.
4. Click "Blind Spot Detection/Rear Cross Traffic Alert (Left) (RVDL)".
5. Click "Special Function".
6. Click "RADAR Alignment".
7. After satisfying the prompt, click "OK".
8. After satisfying the prompt, click "OK".
9. Park the vehicle according to the diagram and instructions, and click 'OK'.
10. Select the car model that needs radar adjustment.
11. According to the description of the picture and text, locate point a, and click "OK".
12. According to the description of the picture and text, locate point b, and click "OK".
13. According to the description of the picture and text, locate the target frame placement point c, and click "OK".
14. According to the description of the picture and text, locate the height of the target placement. Click "OK" to continue.
15. Click "OK" to start the radar adjustment.
16. After the radar adjustment is performed successfully, click "OK".
17. After turning off the ignition, click "OK" to exit.